know you are spending way too
much money for tank heating.
Add up all the totals - the
all too frequent repairs to equipment
that is subject to the constant
vibration inherent with using
direct spargers. Factor in
the capital cost for replacing
the equipment once it is beyond
repair. Consider the higher energy
costs due to poor heat transfer.
And worse, the high cost of downtime
and lost production. Add them
all up and you have a real
problem on your hands…...
You've considered the other
technologies. Indirect heating
with conventional heat exchangers
would work but are more expensive
to purchase, not very energy
efficient and subject to fouling.
solution – The
Q-Jet DSI Direct Steam Injection
Tank Heater. Representing the
state-of the-art refinement
in design, the tank heater
is the first really new option
available in over a decade.
the unique Micro-Jet Array,
the unit offers considerable
benefits over all other tank
heaters. Ideally suited for a
wide range of applications – white
water silo heating, shower wash
heating - any applications where
the process fluid can accept
the injected condensate –
The Q-Jet DSI Tank Heater can
be the answer to your problems.
The key to the
success of the Q-JET DSI Direct
Steam Injection Tank Heater is
the unique design of the Micro-Jet-Array
injected into the process fluid
through an array of small jets. These
small jets transfer heat energy
into a larger exposed surface
area of lower temperature process
fluid than could be attained
using a single large jet of equal cross section. The
injected steam condenses immediately upon contacting
the process fluid in the tank.
Q-JET DSI Tank
Heaters are individually sized
to achieve the specified heating
objective for the application.